Smart-UPS SMT(2U 機架式,型號尾碼「C」,230V)Smart-UPS SMT (2U rack, “C” suffix, 230V)

APC SMT1500RMI2UC 替換電池:APCRBC159APC SMT1500RMI2UC replacement battery: APCRBC159

替換電池對照、更換須知及相關 APC 官方通告。資料來自 APC/Schneider Electric 官方公開資料;未確認的項目標示「請向我們確認」。Replacement battery, replacement notes and related official APC notices, from official APC / Schneider Electric public information. Unconfirmed items are marked “Please confirm with us”.

電池對照Battery lookup

適用替換電池Compatible replacement battery

UPS 型號UPS model替換電池Replacement battery數量Qty更換方式/熱插拔Replacement / hot-swap官方來源Source
Smart-UPS SMT(2U 機架式,型號尾碼「C」,230V)Smart-UPS SMT (2U rack, “C” suffix, 230V)
SMT1500RMI2UCAPCRBC1591用戶可更換;熱插拔:User-replaceable; hot-swap: 請向我們確認Please confirm with usJPS29634
  • 根據官方 FAQ000262042,部分 SMT2200/3000 RM 2UC(UPS ID1046)機身顯示屏或 SmartConnect 介面可能顯示錯誤的 RBC 型號,正確型號為 RBC43。官方表示會以 UPS 韌體更新修正(韌體更新方法見 FA164737)。According to FAQ000262042, some SMT2200/3000 RM 2UC units (UPS ID1046) may show the wrong RBC model on the display or in SmartConnect; the correct model is RBC43. APC states this will be fixed by a UPS firmware update (see FA164737 for how to update firmware).
  • 舊款非「C」型號(例如 SMT1500RMI2U、SMT3000RMI2U)的電池型號請以選擇工具核對。For older non-“C” models (e.g. SMT1500RMI2U, SMT3000RMI2U), check the battery model with the selector tool. 請向我們確認Please confirm with us

需要 SMT1500RMI2UC 電池報價或更換服務?Need a battery quotation or replacement for the SMT1500RMI2UC?

告訴我們 UPS 型號及數量,我們會確認電池型號並提供正式報價。Tell us your UPS model and quantity, and we will confirm the battery model and send a formal quotation. info@solutioneng.com.hk

查詢/報價Enquire / quote
更換指引Replacement guide

換電池須知及步驟Battery replacement notes and steps

安全須知(官方手冊摘要)Safety notes (summary of official manuals)

  • 電池應由熟悉電池及相關防護措施的人員更換,或在其監督下進行。Batteries should be replaced by, or under the supervision of, personnel familiar with batteries and the required precautions.
  • 至少每 5 年更換一次電池,或在電池壽命終結時更換(以較早者為準)。Replace the batteries at least every 5 years or at the end of their service life, whichever comes first.
  • UPS 顯示需要更換電池時,應立即更換。Replace the battery immediately when the UPS indicates that replacement is needed.
  • 如出現電池過熱,或有電解液洩漏的跡象:If a battery overheats or shows signs of electrolyte leakage:
    • 立即關掉 UPS,拔除 AC 輸入,並斷開電池。Turn off the UPS immediately, unplug the AC input and disconnect the batteries.
    • 更換電池之前不要再使用該 UPS。Do not use the UPS again until the batteries have been replaced.
  • 必須使用與原裝相同數量及型號的電池。Use the same number and model of batteries as originally installed.
  • 更換電池或加裝外置電池組時,所有使用超過 1 年的電池模組(包括外置電池組 XLBP 內的模組)都應一併更換。When replacing batteries or adding external battery packs, replace every battery module more than 1 year old at the same time (including modules in XLBP external packs).
  • 操作前除下手錶、戒指等金屬飾物;使用絕緣手柄工具;戴上橡膠手套及穿著橡膠靴。Before starting, remove watches, rings and other metal objects; use tools with insulated handles; wear rubber gloves and boots.
  • 不要把工具或金屬物件放在電池上面;連接或拆除電池端子前,先斷開充電電源。Do not lay tools or metal parts on top of batteries; disconnect the charging source before connecting or disconnecting battery terminals.
  • 不可焚燒、拆開或破壞電池。損壞的電池溫度可能很高,小心燙傷。Do not burn, open or damage batteries. A damaged battery may be very hot; take care to avoid burns.
  • 電池很重,須按安全搬運方法處理。官方數據:Batteries are heavy; use safe handling practices. Official figures:
    • APCRBC140 單個模組約 17 kgAPCRBC140: about 17 kg per module
    • APCRBC152 約 15.3 kgAPCRBC152: about 15.3 kg
    • APCRBC141 約 11.7 kgAPCRBC141: about 11.7 kg
    • 模組上的手柄只用於滑出或推入,不可用來提起搬運。Module handles are only for sliding the module in or out, not for lifting or carrying.
  • 不要使用非 APC 認可的電池:系統無法偵測,可能影響運作,並會令保養失效(990-5269E)。Do not use batteries not approved by APC: the system cannot detect them, operation may be affected, and the warranty is voided (990-5269E).

官方來源:Source: JPS29634 · JPS29632 · 990-5269E · 990-5181B · 990-5299

可否熱插拔(不關機更換)?Hot-swap (replace without shutdown)?

Smart-UPS SMT / SMX:手冊列明電池為用戶可更換(SMX3000RMHV2U 官方標示「User replaceable」);但已查閱的手冊沒有明確寫明可在不關機情況下熱插拔。The manuals list the batteries as user-replaceable (SMX3000RMHV2U is officially marked “User replaceable”), but the manuals reviewed do not explicitly state that hot-swapping without shutdown is supported. 請向我們確認Please confirm with us

官方來源:Source: JPS29634 · JPS29632 · 990-3458G

更換步驟Replacement steps

其他系列(SMT / SMX / SMC / Back-UPS Pro)的步驟請依該型號用戶手冊(連結見對照表)。For other series (SMT / SMX / SMC / Back-UPS Pro), follow the user manual for the model (links in the table).

此型號的官方資料:Official documents for this model: JPS29634JPS29634

另見官方 FAQ FA156520:每個型號的電池更換程序以該型號用戶手冊為準;如手冊內沒有列出,該 UPS 可能不設用戶可更換電池。See also FAQ FA156520: the battery replacement procedure for each model is as given in that model’s user manual; if the manual does not include one, the UPS may not have a user-replaceable battery. FA156520

完整換電池指引Full replacement guide · 更換後:清除警報、自我測試及校準After replacement: clear alarms, self-test and calibration

APC 通告APC notices

相關 APC 官方通告Related official APC notices

按型號、系列或電池型號篩選;日期以官方頁面為準。最後更新:Filtered by model, series or battery model; dates as shown on the official pages. Last updated: 2026-09-30

  • 2026-07-21
    Smart-UPS UPS 韌體套件(SMT / SMX / SMC / SRT / SRTL 等)4.3.8v12aSmart-UPS UPS firmware bundle (SMT / SMX / SMC / SRT / SRTL etc.) 4.3.8v12a

    香港 SMC3000RMI2U 產品頁亦顯示「Latest Firmware (4.3.8v12a)」。The Hong Kong SMC3000RMI2U product page also shows “Latest Firmware (4.3.8v12a)”.

    Smart-UPS Firmware Release NotesSmart-UPS Firmware Release Notes · SMC3000RMI2U 香港產品頁SMC3000RMI2U HK product page

  • 2025-12-18
    FAQ000262042:SMT2200/3000 RM 2UC 顯示錯誤 RBC 型號FAQ000262042: SMT2200/3000 RM 2UC shows the wrong RBC model

    正確型號為 RBC43(日期為官方最後修改日期)。The correct model is RBC43 (date is the official last-modified date).

    FAQ000262042FAQ000262042

查看全部 APC 通告All APC notices

相關型號Related models

使用相同電池的型號Models using the same battery

對照表內沒有其他型號使用 APCRBC159。No other model in the table uses APCRBC159.

查看 APCRBC159 適用的所有 UPS 型號All UPS models that use APCRBC159

資料來源:APC/Schneider Electric 官方公開資料,僅供參考。APC 為 Schneider Electric 商標。Source: official APC/Schneider Electric public information, for reference only. APC is a trademark of Schneider Electric.